Soccer Training on Reliable Artificial Grass

Check whether the foundation works to meet the slope, flatness requirements, clean up the site, soccer field artificial turf site requirements are up to standard. The second point is to put the line, the use of latitude and longitude and the tested steel tape measure to find out the center point of the field, and according to this point to locate the rest of the points on the field, the exact location of the line; lawn conveyor will be artificial grass into the field, along the longitudinal side of the direction of the spreading, and in turn by the longitudinal side of the end of the other end of the advancement; lawn spread out the lawn after the lawn must be checked for the quality of lawn, and observed through the sunlight, so that the grass filaments as much as possible to stand upright. After this use grass cutter will be woven in artificial grass outer edge of the white grass line cut down, placed aside; will turf each seam lap 2-3 cm, use push type grass cutter cut, make both sides of the turf joints tight consistent; will 40cm wide turf connection fiber cloth along the turf seams spread, will lawn bonding special glue with uniformly coated with scraping in the fiber cloth and both sides of the lawn backing cloth.

Adhesive, we measure the outdoor temperature, humidity and wind, reasonable control of the drying time, generally placed 10-25 minutes after the lawn bonding adhesive surface dry about 8 into, judgment standards to not sticky hands as appropriate, the two sides of the turf splicing, and the use of adhesive glued to the fiber cloth. Special attention is the lawn bonding to be completed accurately, not many times back and forth to start and close, this will affect the lawn bonding effect, thus affecting the service life of the lawn. After the lawn is glued, use the lawn sand injection car, full of wheel pressure joints, so that the artificial grass joints bonded more closely and firmly.

In the turf basic splicing is completed, according to the pre-placed line positioning of each point line position, with lawn special cutting knife cut, pull out the cut grass, then 30cm wide fiber backing into the scrape coated with special glue, the original pre-set white grass into the strip, cementing pressure; in the artificial turf basic splicing is completed, due to the stress is not uniform, there may be a local place of the turf appeared on the wrinkled, the correct treatment The right way to deal with it is to cut the wrinkled part with a paper cutter, straighten it and butt it, cut out the overlapped part in the middle, and then cement it;

Sand injection is also known as filling quartz sand, in the artificial grass after all the treatment and clean up, filling quartz sand in the artificial turf, using sand combing truck first half of the specified amount of rubber particles evenly spread on the lawn, so that it is sufficiently dense and flat. Subsequently, the other half of the quartz sand evenly sown, combed into the turf, filled with quartz sand should ensure that the site is flat, good footing, the grass hair is in an upright state.

For more information and to explore our complete range of artificial grass solutions, including artificial grass for soccer fields, artificial grass for field hockey fields and artificial grass for rugby fields, visit our website. Master the game with soccer artificial grass that exceeds expectations for reliability and performance.