solar amber warning Traffic Fog Light

Fog area radar induction system-the fog lamp uses outdoor in-line lamp beads, the lamp beads are red and yellow, the shell is made of cold-rolled plate material, and the pole is used for installation, which is simple and convenient. The lighting mode is flashing, the working voltage is 220V, the controller controls the fog lights to flash synchronously, and the sensor senses that the fog lights are higher than the set value and the fog lights are lit, and the lights are not lit when they are lower.

Highway synchronous fog lights are installed in a large number of foggy areas and long downhill areas. The yellow lights with strong penetrating power are used to warn passing vehicles to slow down. Usually the yellow module flashes. When the fog lights sense that a vehicle is passing through the radar At this time, the red module on the fog lamp will light up for 1 second, and then turn off, warning that there is a car in front of the vehicle behind, pay attention to slow driving; the vehicle driving in the fog area can ensure that the driving is safe from the impact of visibility and can be in the rain, Linear navigation guidance is formed in low visibility environments such as fog, snow, and night, which greatly reduces the occurrence of highway traffic accidents and ensures the safety of people and property.

Warranty period: 2 years

Put the fog radar sensor system-fog lamp on the pole, and the wire needs to pass through the pole; then pass the screw through the base on the lamp and screw them into the holes on the bottom of the lamp. To prevent damage to the lamp by shaking, be sure to tighten the screws. There is a flange on the bottom of the pole, and there are holes on the top. Use screws to fix the pole on the ground or on the safety island.