0.8mm Board to board Male double groove connector

Shenzhen Antenk Electronics Co., Ltd. launched a 0.8mm  Board to board connector, Male,double groove, mating height=4.0~6.5mm electronic products

Board-to-board connector troubleshooting When a board-to-board connector has an open-circuit fault, it may be caused by a broken wire during use, poor connector contact, and loose connector terminals. Since the failure of the wire to break in the middle is very rare, it is mostly disconnected at the connector. Therefore, the inspection should focus on carefully checking the sensor and the wire connecting the cable, if there is looseness and poor contact.

Electrical:
Vlotag Rating:50V AC(rms)/DC
Current Rating:0.5A AC(rms)/DC
Contact Resistance:50mΩ Max
Insulation Resistance:100MΩ min
Dlelectric Withstanding Voltage:200V
AC r.m.s
Operting Temperature:-30℃~+80℃
Materirls
Housing:High Temperature Plastic 
UL94V-0
Terminal:Copper Alloy
Material:PA9T
Contact:phosphor Bronae,Gold Plating;