fingerprint password recognition fingerprint alarm remote control used with home alarm system

Specifications fingerprint password remote control

1.fast delivery

2.Low power LED indication

3.easy install and use function

fingerprint password recognition fingerprint alarm remote control used with home alarm system       Total 50 fingerprints can be restored.   Operation: For first time Default setting: Install as to the guide. Register Fingerprint: Long press ARM/DISARM button same time last about 5seconds till LED light up. Put finger on it to register, hear beep once and fingerprint off and on again, put finger on again to confirm, hear a long beep for register succeed. Register more Fingerprints (only the first 5 fingerprints can be authorized for registrations): Long press (5seconds) both the ARM and DISARM button till the LED and fingerprint window lights with one beep. Put former registered finger on it to authorize, hear beep once. And then put the fingerprint (the follower) on for twice, (3 short beeps for fail register) hear long beep for register succeed. More fingerprints can be continually resisted same way. ---when no operation for 5seconds power off . Clear fingerprint memory: Uncover the case, Press either the ARM or DISARM button to ACTIVATE it, Long press the DEL button on the back PCB, the LED flashes with a long beep for success . Low Battery Warning: After any operation hear 4 short beep and LED flash same time. Need to change battery soon. Change wireless address code: activate and long press “change” button for 5 seconds to hear a long beep to change address code. There are total 254 addresses ARM: press ARM key then press the fingerprint to ARM the system, You will hear a long beep and LED off. DISARM: Press DISARM button , then after the fingerprint light on put finger on it to disarm system. You will hear a long beep and LED off TEMPER SWITCH: Anytime open the case it will give a panic signal to the system then power off automatically LMT5 pin: short connect it for trigger panic alarm when fingerprint wrong for 5 times. Disconnect it for no such limitation     Technical Parameters:

No.	Technical Parameters	Contents
1	Fingerprint Module	30M pixels CMOS with steeples coated glass
2	Fingerprint resolutions	450DPI
3	Acquisition time	<0.5sec
4	Test and verify time	<1sec
5	Cooperation time	1:N
6	False rejection rate(FRR)	≤0.01%
7	(FAR)	≤0.0001%
8	Fingerprint angle	360 degrees
9	Fingerprint setting memory	Confirm twice
10	Fingerprint update	Automatic update
11	Fingerprint template memorize	Changing battery will automatically memorize
12	Most fingerprint numbers	50
13	Light interference	Outer light recognizable
14	Optical glass	Nanometer coated film,enhanced abrasion
15	Standby power consumption	0mA
16	Standby temper	Currency 125uA
17	Dynamic start	Power on mode
18	Working Voltage	Standard battery,4pcs 1.5 alkaline cell,DCV
19	Battery life	>1year
20	Power supply	4 x “AA” Size Battery
21	Storage	Temperature: 5℃---60℃
22	Dynamitic currency	120mA----140mA
23	Low battery Warning	<4.4V
24	Working temperature	-10℃---50℃
25	Dimensions	70mm x 120mm x 35mm

   
                                                                                    Any problems pls contact us, Skype ID: daping_mathy. wait for your kindly order~!!      Product picture: