Infrared Receiver in Casting Mold, 3~5V

Description:
The SEKS Series is Bi-CMOS IC for being used in infrared remote control system.
It consist of automatic gain control amplifier, post amplifier, Oscillator, automatic gain control circuit, a band pass filter, a signal waveform detection circuit, automatic threshold control circuit, a waveform rectifier.

PKG Configuration: Transfer type

Supply voltage: 3~5V

Pin Configuration:
1: Vout-GND-Vcc
2: Vout-Vcc-GND

BPF Center Frequencies Spec: 32.7kHz, 36.7kHz, 37.9kHz, 40.0kHz, 56.7kHz

Features:
1. Supply voltage range: 3~5V
2. TTL and CMOS compatibility
3. No external components except PIN diode
4. Available for carrier frequencies between 32.7kHz to 40kHz,
(Adjusted by zener-diode fusing, 32.7kHz, 36.7kHz, 37.9kHz, 40kHz. )
5. Internal filter for PCM frequency
6. Open collector output (built-in pull-up resistor 42 kΩ )
7. Output active low
8. No occurrence of disturbance pulses at output pin within nominal conditions.
9. Short setting time after power ON (below sec)
10. Enhances immunity against all kinds of disturbance light and power noise.
11. Safety against power supply ripple noise for almost set applications.
(especially, High performance characteristics than the other ICs without electrolytic condenser for power noise suppression. )

Applications:
TV, VCR, AUDIO
Home appliances
Remote control equipment