High Power Flexible LED Strip (SC-XID1-W)

LED Strip
1. High power flexible SMD LED strip, max. 77W
2. LED Strip Length: 5000mm, packed with a reel
3. Assembled with 1200PCS high power SMD LEDs, 24V
4. LED Strip Power consumption 15.4W per meter
5. LED Strip Working current: 0.64A per meter
6. Very high light output, over 1200 lumen per meter
7. LED beam angle 120°
8. Available color: Cool white 5800-6500K, neutral white 4000-4500K and warm white 3000-3500K, red, yellow, blue, green.
9. Every 6LEDs ( one row ) can be cut, nice accessories like strip to strip connector, strip to power connector, " L " shape connector, " T" shape connector are available
10. Available in waterproof version IP65.
11. Comes with 3M tape on strip back
12. Easy installation
Dimension drawing(Unit:mm/inch)

LED Strip Application
- cove lighting
- Architectural lights for canopy, corridor, window, archway
- Back light or edge lighting for signage
- DIY lights for home use
- Path and contour marking
- Decorative lights for holiday, event, show, exhibition


Assembly Information:
- Solder connection should only be performed on designated solder pads (marked " +/-"). During
Soldering, don't exceed the maximum soldering time of 10 seconds and the maximum soldering
Temperature of 260 Celsius degrees.
- The smallest unit (50mm - 6 LEDs) can be removed by cutting with scissors between the
Designated solder pads.
- The mounting of the strip is facilitated by means of the double-sided adhesive on the back-surface Of the strip. Care must be taken to provide a clean and dry mounting surface, free of oils or silicone Coatings as well as dirt partide. The mounting substrate must have sufficient structural integrity.
Take care to completely remove the adhesive backing. Once the strip is appropriately positioned.
Press on the strip with about 20N/cm² (refer to ap-plication techniques of 3M adhesive transfer tapes).
- The minimum bending radius is 2 cm. The strip may be bent over a smaller radius of the circuit
Board contain-ing no electronic components and such bends should be made once and fixed in Position to avoid cyclic fatigue.

Safety Information:
- Damaged by corrosion will not be honored as a materials defect claim. It is the user's Responsibility to provide suitable protection against corrosive agents such as moisture And condensation and other harmful elements.
- The strip itself and all its components may not be mechanically stressed.
- Assembly must not damage or destroy conducting paths on the circuit board.
- Installation of LED ribbon (with power supplies) needs to be made with regard to all applicable Electrical and safety standards. Only qualified personnel should be allowed to perform installations.
- Correct electrical polarity needs to be observed. Wrong polarity may destroy the strip.
- Parallel connection is highly recommended as safe electrical operation mode.
- Serial connection is not recommended. Unbalanced voltage drop can cause hazardous overload And damage the strip.
- Please ensure that the power supply is of adapters power to operate the total load.
- When mounting on metallic or otherwise conductive surfaces, there needs to be an electrical Isolation points between strip and the mounting surface.
- Pay attention to standard ESD precautions when installing the strip.