Cool Design Hot Selling Variable Voltage E-Cigarette Mod Kit Vamo V2

Cool Design Hot Selling Variable Voltage E-Cigarette Mod Kit Vamo V2

E cigarette Vamo V2 features:

1. Adjust the voltage from 3.0-6.0 as well as the watts from 3.0-15.0 on the menu design.
2. LCD menu display with the 2 buttons below the screen to adjust your volts or watts.
3. Smooth button that allows you to easily fire the mod.
4. Menu settings that you can use to change the menu display.
5. Suit most resistance atomizers (above 1.2 ohms). The Vamo has a 1.2 ohm cut off feature.

Vamo V2 kit conment:

Battery body: 1pcs
Battery: 2pcs
Atomizer: 2pcs
Battery charger: 1pcs
Manual: 1pcs
Giftbox: 1pcs

Advantages

(1)If you push the 2 top buttons at the same time on the Chrome Vamo V2 you can change the settings form volts to watts.
(2)If you hold the (+) right button for 3 seconds you can read the ohms in your atomizer tank.
(3)if you hold the (-) button on the left, the Chrome Vamo V2 will tell you the battery life left on your current battery.

How to use chrome Vamo VV/VW Mod Body V2:

(1)Turn On or Off:
Press the Power (large) button 5 times within 2 seconds.
(2)Switch between VV and VW:
Press and hold + and - buttons for 3 seconds (v for volts, w for Watts).
(3)Voltage adjust:
Tap the + or - buttons to raise or lower output voltage (in. 1 volt increments).
(4)Wattage adjust:
Tap the + or - buttons to raise or lower output wattage (in. 5 watt increments).

IMPORTANT

The Vamo can display output voltage and wattage as an Average or as RMS (Root Mean Square). RMS is the actual and true output and is the one to use.
Press and hold the + button for 10 secs. If no2 is shown then the output is already set to RMS, no further action is required. If no1 is shown, release the button and press again for 10 secs until the display shows no2. This setting should not alter after a battery change, however if the vape feels warmer than expected please re-check setting.

Reminder

Resistance check:
With an atomiser or cartomiser installed on unit, press and hold the + button for 2 seconds. Atomiser resistance is displayed in ohms.

Battery voltage check:
Press and hold the - button for 2 secs to check actual battery voltage

Display will flash when battery needs replacing/recharging (approx 3.4v).
Voltage or wattage level resets when battery is removed, the mode does not.