2m656 2 Phase Stepper Motor Electric Driver

Introduction
2M656 is a cost effective, hig performance bi-polar two phase micro-stepping drive applying pure-sinusoidal current control technique. It is best suited for the applications that desired extreme low noise and heat. It operates well in an environment, where electricity supply experience instability and fluctuation.
The general pseudo-sinusoidal current control technology adopted by majority of the drive produced distorted sine wave, and current ripple, resulting in vibration, noise and motor heating. This results in motor degrading over time, reducing in motor performance and shortens the usage life.
With an automatic optimization speed control technique, the Powerstep series drive output is very stable, with almost zero vibration and noise, performing close to a servo system, allowing the motor to operate smoothly. That helps to fulfill a design requirement of low noise, low heat ND high performance.

Key Features:
1.24 to 48VDC Supply Voitage
2. H-Bridge, 2Phase Bi-plar Micro-stepping Drive
3. Suitable for 2-phase; 4, 6and 8 leads step motors, with NEMA size 16 to 34
4. Output current selectable from 1.4~5.6A peak
5. Current reduction by 50%automatically, when motor standstill mode is enabled
6. Pulse Input frequency up tu 200 kHz
7. Optically isolated diffeential TTL inputs for Pulse, Direction and Enable signal inputs
8. Selectable resolutions up to 12800 steps
9. Over Voltage. Coil Coil and Ground short circuit protection

Specifications