NEMA 17 Stepper Motor Driver

Stepper Motor Driver 2M415 

1)stepper motor driver:
2)low cost
3)low noise
4)low heat
5)high performance
Description of step motor driver:
Key Features:
1. +15 to 40VDC Supply Voltage
2. H-Bridge, 2 Phase Bi-polar Micro-stepping Drive
3. Suitable for 2-phase, 4, 6 and 8 leads step motors, with NEMA size 16 to 23
4. Output current selectable from 0.21 ~ 1.5A peak
5. Compact credit card size package
6. Optically isolated single ended TTL inputs for Pulse, Direction and Enable signal inputs
7. Selectable resolutions up to 12800 steps
Over Voltage, Coil to Coil and Coil to Ground short circuit protection.

Introduction
2M415 is a bi-polar two phase micro-stepping drive in a compact credit card size package. It is design for ultimate performance at a very cost efficient operation. It is best suited for two phase small size motor, which requires very little current, to deliver good speed and torque result. The single ended Pulse, Direction and Enable inputs with Opto-coupler pull up, interface perfectly with majority of the PLC output or PLC motion controller, shortening set up time.
With an automatic optimization speed control technique, the PowerStep series drive output is very stable, with almost zero vibration and noise, performing close to a servo system, allowing the motor to operate smoothly. That helps to fulfill a design requirement of low noise, low heat and high performance.