TV Remote Controller of Sky HD

TV remote control/ TV remote controller/ Remote Control of Sky HD
TV + SKY digibox
2\ OPERATING GUIDE
(TV + SKY digibox & TV + SKY digibox w/ Playback buttons)
2.1 Code Setup
<1> Press and release the TV button.
<2> Press and hold the Select and Red buttons together for 2 seconds, until the LEDlights up.
<3> Input the code numbers (4 digits) which found from the code list.
<4> After input the 4 digits code number, the LED will turn off if the code number iscorrect. If the code number is not in the list, the LED will flash twice and keep in the setup status, please back to the step <3>.
2.2 Set the TV channel for watching satellite TV
<1> Press and release the TV button.
<2> Press and hold the Select and Green buttons together for 2 seconds, until theLED lights up.
<3> Select the number of channel on your television that you use for watching satelliteTV.
<4> Press the Select button, the LED will be turn off.
2.3 Code Search
<1> Turn your television on.
<2> Press and release the TV button.
<3> Press and hold the Select and Red buttons together for 2 seconds, until the LEDlights up.
<4> Press 9 9 1, the LED will be flash.
<5> Aim the URC at your device, press and release the Power button slowly, the URCwill send the Power signal of next table. Check the television activate or not (Power off). Go to step <6> for activate or repeat step <5> for not.
<6> Press the TV button.
2.4 Test Mode (for Manufacturer use only)
Manufacturer can use this mode to test the keypad and transmission functions.
<1> Follow the Code Setup procedure to set TV's brand code as 9 9 9.
<2> The system going to check the internal ROM code (take about 2 seconds).
<3> The LED lights up then enters Test Mode if ROM code passed, or the LED flashes 3 times then enters Test Mode if ROM code failed.
<4> Press any button and the system will send out the Test Code of that key. with the Test Module can test each button is function or not. Repeat the step <4> until all thebuttons are tested.
<5> Press the TV button once to leave the Test Mode, the LED will turn off. (the TV button would be the last tested, it can leave the Test Mode at the same time. )
Remark: System will leave the Test Mode automatically when after 30 sec. Have not pressany button.