T850 Shock Collar for Barking Dogs' Training

Remote vibrating dog training collar, pet dog training collar

1) With LCD display
2) Range up to 300 meters
3) Featured power saving design
4) Remote 2 dogs at the same time
Features:
1.100 level of vibration
2.100 level of static(optional)
3. The levels can be altered by use of up & down button
4. A tone button activates a tone on the receiver
5. The system can be used for 1 or 2 receivers
Users Manual for Transmitter:
To install the batteries, open the battery cover
The battery cover is at the back of the transmitter
Open by sliding the cover down
Install the batteries (2× 4LR44/6V) - ensure the polarity is correct
The transmitter will be TURN ON automatically
Press the buttons one by one - the LCD images will change
Press the up and down buttons on right hand side to set level
Choose channel 1 or 2 for the first or the second receiver
The LED light can be used for giving training signals
The transmitter will go into STANDBY MODE if not operated for 2 minutes and will TURN OFF if not operated for 5 minutes
In STANDBY MODE, press any button (except LED light button) to wake it up
To TURN ON the transmitter, hold mode button at least 5 seconds
Power Saving:
1. The receiver will TURN OFF if it is unused for 4 minutes
2. Any movement will activate the receiver into STANDBY MODE
3. The transmitter will go into STANDBY MODE if there is no operation after 2 minutes and turn off 5 minutes
Connect the transmitter with the receivers:
Before using this system, please connect your transmitter with your receivers.
1. Install the battery(2× 4LR44/6V) in the transmitter and ensure the polarity is correct.
2. Adjust the channel button to the right one you want to stay.
3. Install the batteries(2× AAA 1.5V) in the receiver (please refer to how to install the batteries in receivers)
4. There is a beep right after installing the batteries in the receiver.
5. Press the Launch button from the transmitter to encode the transmitter and the receiver immediately. There is a beef again from the receiver if you encode successfully.
6. Replace cover and tighten metal probes.
7. If there is no response from th receiver, reinstall the batteries from the receiver and press launch button again.
8. This system could train up to 2 dogs at the same time.
To encode different dogs, just change to different channel and repeat the procedure as described again.