liquid molds silicone for interior decorative columns

APPLICATIONS of liquid molds silicone for interior decorative columns:

E630 liquid silicone rubber could be mainly used for making concrete stones, precision molds, PU molds, resin molds, gypsum casting, candle molding, for life casting, fabric finishing, seal for electronic components and solar circuit board, trademark decoration. etc.

Datasheets of liquid molds silicone for interior decorative columns

FEATURES of liquid molds silicone for interior decorative columns

Two-parts, flowable liquid silicon & curing agent.

Can solve the problem of not lighting of the candles and the problem of sticky and white stains on the surface of cement & stone products.

Good tensile strength and tear strength,low shrinkage.

 It gets cured at room temperature 25 ⁰C within 5-7 hours.

An exceptional fluidity and good operability, easy to be demolded.

Suitable for pouring methods of operation for small sized molds making.

OPERRATING INSTRUCTION of price liquid silicone rubber for mold making decorative concrete:

1.Stir part A and part B with right mixing ratio

evenly. And get the mixture for vacuum-

pumping. (If there is no vacuumizer,you can just pour the mixture slowly from the corner so that less bubbles caused).

2. Enclose the product (the original model) with four plastic plates or wooden plates.

3. Clean your products and brush a layer of release agent(detergent or soap water) on your product.

4. Pour the mixture with correct mixing ratio into the model frame.

After about 2-4 hours, when the silicone cured, get out the original model, and there you get a finished addition cured silicone mold .

SHELF LIFE of liquid molds silicone for interior decorative columns:

Twelve (12) months from date of shipment when stored at 24°C in original unopened packages.

PACKAGE and certificats:

Packed in clean 5kg/pail, 25kg/pail, 200kg/pail.

Frequently Asked Questions

Why does the silicone rubber mold have few molding times?

 The silicone rubber mold has few molding times is due to follwoing reasons: adding too much silicone oil which will destroy the molecular of silicone rubber; making the mold for small and fine detailed products with higher hardness silicone rubber which is easy to break; making the mold for large products with soft silicone rubber which will reduce the tensile and tear strength of the mold, and the mold will have deformation. Thus, we should take the proper silicone rubber to make the mold for suitable products.