HDMI Extender UTP Cable

HDMI extender utp cable
P/N:CEHEDE102

1.0 Introduction

The Extender is based on the HDBaseT technology. It extends your HD display with the resolutions of 1080p/60Hz up to 330ft away from your HDMI or DVI-D source by using one CAT5e/6 cable. It also extends Ethernet and provides an IR back channel to control AV sources using the same CAT5e/6 cable. The Ethernet port on both the Sender and Receiver are connected to standard network devices such as 100Base-T routers and hubs.
The RS232 port on both are also connected to standard RS232 sink device or control equipment especially for Industrial project control .
With Power over Ethernet function, the extender can pass electrical power safely along with data on single Ethernet cabling. 
  
 

1.1Features

• Supports HDCP
• Supporst uncompressed HDMI signal.
• Enables HDMI10.2 Gbps and 100Mbps Ethernet in parallel over a single 100m Cat5e/6 cable.
• Supports 340MHz/3.4Gbps per channel (10.2Gbps all channel) bandwidth.
• Supports 1080p@60Hz@48bit pixels
• Supports 3D pass-through.
• Supports CEC pass-through.
• Supports uncompressed audio such as LPCM.
• Supports compressed audio such as DTS Digital, Dolby Digital（including DTS-HD and Dolby  True HD）.
• There is one standard Ethernet port on both sender and receiver respectively，which is bidirectional data transmission.
• Built-in IR extender function allows IR remote control of Source devices from remote viewing location by sending IR commands received in the vicinity of the Display back to the Source devices.
• CAT5e/6 cable follows the standard of IEEE-568B.
• Supports RS232 SingleTwo-way communication. 
• Supports Power over Ethernet.

2.0 SPECIFICATIONS

3.0 Package Contents

 
Before attempting to use this unit, please check the packaging and make sure the following items are contained in the shipping carton:

1. Main unit No. 1 Sender
2. Main unit No. 2 Receiver
3. One piece of 48VDC Power Supply
4. IR(Extender infrared receiver) X1
5. IE(Extender infrared emitter) X1
6. User’s Manual